Radiant Heat USA Rotating Header Image

Taco Heating Valves

Nominal pressure of PEX fitting

Jun 29th, 2010
by admin.
Comments are off for this post

Nominal pressure is the only parameter PEX fitting, which ensures its durability and accounted for as operating pressure and operating temperature. Nominal pressure corresponds to the allowable working pressure of the product at normal temperatures. With increasing temperature, the mechanical properties of structural materials deteriorate. Therefore, for valves with a high operating temperature allowable working pressure is lower than conventional. This reduction depends on the material details of fixtures and the temperature dependence of the strength properties of the material. The higher operating temperature, the lower the maximum operating pressure at the same relative pressure.

To make the overall clarity in the operational and design features of the use of Taco heating valves is proposed to be classified by the following parameters:

1. by the method of the overlap of the flow;
2. on the application;
3. depending on operating environment and its parameters;
4. the material base parts;
5. by the method of administration;
6. by functional purpose;
7. by the method of accession to the pipeline;
8. largest diameter of the port area;
9. largest conditional pressure.

Warm floor: Taco Heating Valves Tips

May 14th, 2010
by admin.
Comments are off for this post

The main option seems simpler: the existing floor is laid fuel cells, is pouring over a thin layer (2-3 cm) cable ties. But if in the first case we have an opportunity to lay a thick layer of insulation (3-5 cm), and pour concrete over a thickness of about 5 cm, in the second case, we do not even know what is in the body of the old floor. There may lie metal beams or other structures, which will lose heat even on street walls. Therefore, if you can put a layer of insulation, the power falling on a square meter of the floor, will be small – 90-120 W/m2. A layer of insulation if not, you will have to compensate for the loss of heat excess installed capacity.

If we do a full system of PEX radiant heating, the first is thermal design, and only then – to select the necessary equipment. It is this: if the floors, electrical, then the cable  in a thick concrete screed (not less than 10-15 cm), which plays the role teploakkumulyatora. This solution is used forPEX radiant heating of offices, production areas and where there are no people at night. After all reasonably possible to heat the floor at night when electricity grid is generated in excess and it is cheap. But during the day take advantage of the warm night. The same system can be constructed on the basis of water-heated floors. But there teploakkumulyatora role will play a special capacity drive, in which the coolant is heated to maximum temperature.

If  then by means of special Taco heating valves are added to this heated coolant is circulating in the system that allows long-term use of previously accumulated heat. With direct PEX radiant heating control system continuously monitors the air temperature in the room and, if necessary, includesPEX radiant heating, regardless of time of day and the tariff.


pex